The Brass End Plug is used to easily and effectively stop water flow at the end of a mist system line that uses a Slip-Lok fitting. The end of a Slip-Lok fitting can be removed by compressing the ferule of the Slip-Lok against the fitting body and then pulling the end plug away from the fitting. The end plug is compatible with any 3/8 In. mist cooling system.

The Brass Nozzle Plug is used in place of a mist nozzle on all outdoor mist cooling systems. These plugs are used to replace nozzles in the off season when the mist system is not used and the mist nozzles are being stored. Nozzle plugs prevent debris and insects from entering the mist line and clogging the system. They are also useful to plug off openings when less mist is desired.

The Brass and Stainless Steel Mist Nozzle is the most efficient and water conservative mist nozzle available today. It only uses one half gallon per hour per nozzle and features a sturdy brass body with stainless steel orifice. The nozzle requires simple maintenance; soaking periodically in misting nozzle cleaner to remove mineral deposits that may accumulate with usage.

A Mist Calcium Inhibitor Filter is recommended for use on any mist system and should be changed annually. This filter protects the misting system in two ways; it stops solid sediments, as small as 5 microns, from passing through the system, clogging the nozzle orifice, and coats smaller particulates with polyphosphates which enables them to pass easily through the nozzle orifice without forming blockages. A mist filter prolongs the life of the mist nozzle and inhibits nozzle clogging.

The Stucco Installation Kit contains a blue stucco anchor, masonry screw, and a 3/8 In. wrap around clamp used for outdoor mist cooling sytem installation. The kit can be used for installation into stucco, wood, and metal surfaces.

The Slip-Lok Tee is used to connect outdoor mist cooling system lines and assembles in seconds with a simple insert and twist motion. The unique brass Slip-Lok design can be used with both low and high pressure (up to 160 psi) systems as the tee actually grips tighter when the pressure increases. Additionally, the tee and tubing can be disassembled by simply compressing the ferule against the body and pulling away from the tubing making the Slip-Lok tee a versatile mist system fitting.

The unique Brass Slip Lok Design is applicable in both low and high pressure mist system applications. The Slip Lok Fitting with Mist Nozzle, coupled with 3/8 in. nylon tubing, assembles in minutes with a simple insertion and twist motion to create a mist system up to 125 linear ft. They actually grip tighter as the pressure is increased and can be used with mist pumps that pressurize up to 1000 PSI. The fitting can be rotated a full 360 degrees to direct the mist where needed. It can also be disassembled from the tubing by simply compressing the ferrule against the body and pulling away from the tubing. These features make it the most versatile mist system fitting available.

The Slip-Lok Coupling is used to connect outdoor mist cooling system lines and assembles in seconds with a simple insert and twist motion. The unique brass Slip-Lok design can be used with both low and high pressure (up to 160 psi) systems as the coupling grips tighter when the pressure increases. Additionally, the coupling and tubing can be disassembled by simply compressing the ferule against the body and pulling away from the tubing, making the Slip-Lok coupling a versatile mist system fitting.